2023 Husqvarna FE 250 Specifications

Enduro / Off-Road

Advertisement
No images available
Tap to enlarge

2023 Husqvarna FE 250 Overview

The 2023 Husqvarna FE 250 is an enduro / off-road motorcycle built around 249.9 cc of displacement. Under the tank sits a Single cylinder, four-stroke engine running Double Overhead Cams/Twin Cam (DOHC) valve actuation, a compression ratio of 14.5:1. The bore and stroke measures 81 x 48.5 mm. From a practical standpoint, the 2023 FE 250 tips the scales at 101.2 kg, carries a 7.20-litre fuel tank, offers a seat height of 950 mm and spans a 1482 mm wheelbase. Scroll down for the complete 2023 Husqvarna FE 250 spec sheet covering every technical detail from suspension travel to tyre sizes.

2023 FE 250 - Pros & Cons

Strengths

  • Factory engineering: The 2023 Husqvarna FE 250 represents Husqvarna's engineering at the time, with a specification built around real-world usability.

Considerations

  • Carburetor fuelling: Carbureted engines need occasional jetting attention and can be reluctant in cold weather or at altitude compared to modern fuel-injected alternatives.
  • Tall seat height: The 950 mm seat height will challenge shorter riders - tiptoeing at low speeds is something to factor into your decision.

Owner Experiences & Common Issues

Carburetor maintenance

Carburetors on the 2023 Husqvarna FE 250 benefit from a clean and re-jet if the bike has been stored, run on stale fuel, or modified with an aftermarket exhaust. Owners frequently mention that fresh jets and float needle clips transforms throttle response from flat to crisp.

Valve clearance checks

Double Overhead Cams/Twin Cam (DOHC) engines should have valve clearances checked at the manufacturer's specified interval. Owners report that clearances can tighten over time on higher-mileage bikes, leading to slight ticking from the top end. Catching it early keeps the job simple and avoids more costly remediation.

FE 250 - Buying & Maintenance Guide

What to check before buying

When inspecting a used 2023 Husqvarna FE 250, start with the basics: check the service book for oil change frequency, inspect the chain and sprockets for wear, and look for oil seepage around the engine casings and rocker covers. A cold start test is invaluable - a well-maintained FE 250 should fire up cleanly and settle to a smooth idle within a few seconds.

Oil and filter changes

Regular oil changes are the single most important maintenance task on any FE 250. Stick to the manufacturer's interval - typically every 6,000 km or once a year, whichever comes first. Always use the correct viscosity grade as specified in the owner's manual.

Carburetor upkeep

Keep the carburetors clean and free of deposits. If the FE 250 has been stored, strip and clean the carb float bowls before attempting to start it. Pilot jets are the first to block and the last to be checked - always include them in any carb rebuild.

Valve clearance service

Check that valve clearances have been adjusted at the correct intervals on any used FE 250. This is a job many owners skip because the bike does not immediately feel wrong - but tight clearances accelerate valve seat wear. Ask for proof it has been done.

2023 Husqvarna FE 250 - Frequently Asked Questions

What engine does the 2023 Husqvarna FE 250 have?
The 2023 Husqvarna FE 250 uses a Single cylinder, four-stroke engine with 249.9 cc of displacement.
How much does the 2023 Husqvarna FE 250 weigh?
The 2023 Husqvarna FE 250 weighs 101.2 kg. This is the manufacturer's dry figure.
What is the fuel tank capacity of the 2023 Husqvarna FE 250?
The 2023 Husqvarna FE 250 has a 7.20-litre fuel tank.
Is the 2023 Husqvarna FE 250 suitable for shorter riders?
The 2023 Husqvarna FE 250 has a seat height of 950 mm. This is towards the tall end of the spectrum and will require most riders under 175 cm to tiptoe at stops.
What brakes does the 2023 Husqvarna FE 250 have?
The 2023 Husqvarna FE 250 uses Single disc. GSK Wave disk. at the front and Single disc. GSK Wave disk. at the rear.
What tyre sizes does the 2023 Husqvarna FE 250 use?
The front tyre size on the 2023 Husqvarna FE 250 is 90/90-21.
What fuel system does the 2023 Husqvarna FE 250 use?
The 2023 Husqvarna FE 250 uses Carburettor, providing precise fuelling across the rev range and reliable cold-start behaviour.

Husqvarna FE 250 Spec Evolution

The Husqvarna FE 250 was produced across 7 model years (2015-2023). The table below highlights the key specifications that changed across the production run - useful whether you are comparing years or tracking down a specific variant.

Specification 2015 2017 2018 2019 2021 2022 2023
Dry Weight 107.5 kg / 237 lbs 107.5 kg / 237 lbs 108.3 kg / 238.8 lbs 105.8 kg / 233.2 lbs 106 kg / 233.7 lbs 106 kg / 233.7 lbs 101.2 kg / 223.1 lbs
Engine Detail Four stroke. single cylinder. DOHC. 4 valve per cylinder Four stroke. single cylinder. DOHC. 4 valve per cylinder Lightweight titanium valves Lightweight titanium valves - - -
Seat Height 970 mm / 38.2 in 970 mm / 38.2 in. 970 mm / 38.2 in. 970 mm / 38.2 in. 950 mm / 37.4 in. 950 mm / 37.4 in. 950 mm / 37.4 in.
Fuel Capacity 9.5 Litres / 2.8 US gal 9.5 Litres / 2.8 US gal 8.50 litres / 2.25 gallons 8.50 litres / 2.25 US gallons 8.50 litres / 2.25 US gallons 9.00 litres / 2.38 US gallons 7.20 litres / 1.90 US gallons
Ground Clearance (mm) 345 mm 345 mm 370 mm 370 mm 360 mm 360 mm 360 mm
Ground Clearance (in.) 13.6 inches 13.6 inches 14.6 inches 14.6 inches 14.2 inches 14.2 inches 14.2 inches
Fuel Control DOHC Double Overhead Cams/Twin Cam (DOHC) Double Overhead Cams/Twin Cam (DOHC) Double Overhead Cams/Twin Cam (DOHC) Double Overhead Cams/Twin Cam (DOHC) Double Overhead Cams/Twin Cam (DOHC) Double Overhead Cams/Twin Cam (DOHC)
Displacement (cc) - 249.91 cc 249.91 cc 249.9 cc 249.9 cc 249.9 cc 249.9 cc

Key Specifications

Engine

Single cylinder, four-stroke

Power

N/A

Torque

N/A

Top Speed

N/A

Weight

101.2 kg / 223.1 lbs

Fuel Capacity

7.20 litres / 1.90 US gallons

Advertisement

Full 2023 Husqvarna FE 250 Specifications

Comments Traction Control.
Colours White/yellow/grey
Power-to-Weight Ratio 0.4545 HP/kg
Stroke 4-stroke
Fuel Control Double Overhead Cams/Twin Cam (DOHC)
Engine Type Single cylinder, four-stroke
Displacement (ci) 15.25 cubic inches
Displacement (cc) 249.9 cc
CO2 80.5 CO2 g/km. (CO2 - Carbon dioxide emission)
Bore x Stroke (in,) 3.2 x 1.9 inches
Bore x Stroke (mm) 81.0 x 48.5 mm
Fuel System Carburettor
Compression Ratio 14.5:1
Fuel Consumption 3.47 litres/100 km (28.8 km/l or 67.79 mpg)
Ignition Keihin EMS
Starter Electric
Advertisement